FAQ

How to use conduct measurement report

  1. Use meta data to generate report(s)
    1. Create Report
      After login by username and password Visit CDM reports index page, User can review historical reports, if there is any newly uploaded test data, a prompt and the "Create Report" button will be generated. Click "Create Report" to proceed... report_list


    2. Multi-select meta data to generate bulk reports
      create_report

    3. Preview loaded limitation lines
      report_preview

    4. Click "Save" button to generate and save report(s)
      save_report

    5. View test report
      edit_list

    6. View the test report. You can change the start or stop frequency of the report spectrum, and then click the "enlarge" button to observe the spectrum in desired frequency range (option). Click the "Print" button to save the test report as PDF (optional)
      print_report
      Generated pdf file as shown below

      report_pdf

  2. Edit generated EMI Report
    1. Visit the index page where the reports are listed, and click the "Edit" button
      edit_list

    2. Enter the edit page to edit. Among them, the editable part is highlighted, and the uneditable part is gray.Click the "Reset" button to cancel the editing, click the "Save" button to save the editing results
      edit_report
      The editable field is highlighted, the uneditable field remains gray
  3. Cloud computing assisted rectification
    1. Waveform comparison before and after rectification

      Before change report: 2020-09_01627

      cdm_before

      After change report: 2020-09_01629

      cdm_after

      Select the above two reports on the selection list and click the "Compare" button

      cdm_compare
      cdm_compare_button

      Show comparison results

      cdm_compare_result

      Click the "Print" button on the panel of the comparison page to generate a PDF report (optional):

      cdm_compare_detail

    2. Environmental interference cancellation above 30MHz

      The DC supply is disconnected while wiring is normal, the test result shows the environment interference

      Report Id: 2021-05_01965

      env_signal

      The DC supply is connected while wiring is normal, the test result shows the EUT's conduction interference

      Report Id: 2021-05_01966

      eut_signal

      Cancel 2021-05_01965 report's signal from 2021-05_01966 report's

      cdm_denoise
      denoise_button

      Show comparison results

      denoise_result

      Click the "Print" button under the denoising report page to generate a PDF report (option):

      denoise_detail
  4. Learn how to upload test data....
  5. Learn more about EMC test....